Skip to content
欢迎使用 微信支付 Wechat Pay 及 支付宝 Alipay
欢迎使用 微信 Wechat Pay 及 支付宝 Alipay

[Lindemann] musicbook POWER 1000 II *(Pre-Order)*

Original price $33,200.00 - Original price $33,200.00
Original price $33,200.00
$33,200.00
$33,200.00 - $33,200.00
Current price $33,200.00

*(Pre-Order)*

Due to the current pandemic, order lead time could be delayed around 4-6 weeks.

因疫情關係,訂單有機會延遲交貨4至6週。

What makes actually a good power amplifier? Sufficient output, good technical specs with low distortions and a high damping factor, perhaps also a high efficiency. This is certainly true, but doesn’t say much about the acoustic result we can achieve with a loudspeaker. A really good power amp can drive a loudspeaker in such a way that even the very last ounce of musical information becomes perceivable. And always in a sovereign and very relaxed manner.

The Musicbook POWER II is not only the ideal game partner for the Musicbook SOURCE, but also knows how to get even the finest musical details out of a loudspeaker. Of course, with excellent measured values and minimal power consumption.

Technical specifications:

Please note: The values in brackets apply to the POWER 1000!

General
Mains connection: 90-240 V, 50-60 Hz
Power consumption: 0,5 W stand-by, 16 (26) W operation, 650 (1200) W max.
Dimensions (W x H x D): 280 x 220 x 63 mm
Weight: 2,9 (3,4) kg

Power amps
XLR Inputs: balanced, analog line-level inputs
Input voltage for full modulation: 1,68 V (2,38 V)
Input impendance: 20 kOhms
Speaker outputs: banana plugs (4 mm)
Speaker impendance range: 4 – 8 Ohms
Output power: 2 x 250 W @ 4 Ohms (2 x 500 W @ 4 Ohms)
Gain: 26 dB
THD: < 0,003%
Frequency response: 1 Hz – 50 kHz (-3 dB)
Signal-to-noise ration: > 110 dB

Automatic switch-on
Switch-on treshold: ca. 0,2 mV balanced
Switch-on delay: ca. 2-3 seconds
Switch-off time: ca. 60 minutes

Protection circuits
DC at output: Amplifier switches off. The display lights up red continuously. The unit must be disconnected from the mains for 10 seconds and restarted.
Overtemperature: Amplifier flashes red. Cause: Overload, insufficient convection cooling, room temperature too high. If the temperature continues to rise, the amplifier is switched off, until the unit has cooled down.
Current limiting: Amplifier switches off the signal. Switching threshold output current: 17.5 A (27 A)